Extended hinge cover for Ariete 909 pizza oven

WARNING Electrical and fire hazard: All modifications to your cooking appliances are at your own risk, only proceed if you have the right knowledge, and with quality electrical parts. 

Hi,
this is a copy of the original hinge cover for a Ariete model 909/917/918/928 oven, except it is 30 mm deeper and with a 20 mm hole to accomodate a 6 amp 230V switch. You can find the dimensions of the switch I used in the “assembly guide” section.

I also made a version of the cover without any hole, so you can make your own (in your slicer or otherwise) according to the switch you have on hand. You will find this version on a separate printing profile, and as a separate .stl

I made this part to allow a popular mod on this oven, which consists of a switch to control separately the lower heating element. With this cover, the mod is completely reversible, as you can keep untouched to original cover.

I chose this emplacement for the switch as the wiring runs through this hinge, and you can easily disconnect the white cable and feed it through the switch. You can use the original screws, but on my part i picked 3 mm wood screws, as I don't have a special screwdriver thin enough to go in the holes.

Moreover, the temperature at the hinge is low enough to use PLA for the part, but i highly suggest to use ABS or even better, some sort of PA/Nylon to be on the safe side.

A bit of a niche part but i'm sure there is many pizza lover in this world :)

WARNING Electrical and fire hazard: All modifications to your cooking appliances are at your own risk, only proceed if you have the right knowledge, and with quality electrical parts. 

Don't forget to like, or even spending your free Boost if you feel it is deserved! Giving your thoughts and advice in comment will be read and apreciated too. Thank you!

I'm looking forward seeing your creations in the comment section.

In case of problem, please contact me, solutions are seldom far away :)