Molle Glock Magazine Holder- BearToad EZ Molle

Molle Glock Magazine Holder - BearToad EZ Molle System

Precision meets performance. The BearToad EZ Molle Glock Magazine Holder is a high-retention, quick-access solution for your 9mm Glock magazines. Whether you’re kitting out the back of your 4Runner, the back of your seat, a visor , or a bedside mounting panel, this holder ensures your mags are exactly where you need them.

Engineered with the signature EZ Molle interface, you can move your loadout from a bag to a belt or a vehicle panel in seconds.

The BearToad Difference

Traditional fabric pouches can be slow to draw from and a pain to re-index. Our hard-shell magazine holder provides a consistent, friction-fit draw every time. We designed this specifically for the double-stack Glock platform (G17, G19) to provide a secure fit without the need for cumbersome bungee cords or Velcro flaps.

Features

• Positive Retention: Friction-tuned geometry holds the magazine securely even upside down, while allowing for a smooth, fast draw.
• Rapid Reconfiguration: Move your mags across any Molle-compatible surface instantly with our tool-less EZ-Mount lugs.
• Slimline Profile: Minimalist design allows you to "stack" multiple holders side-by-side without wasting valuable Molle real estate.
• Ambidextrous Mounting: Can be mounted for left or right-handed draws depending on your panel orientation.
• Bambu Lab Optimized: Fine-tuned for the P and X series to ensure the interior dimensions are exact for a perfect fit.

What’s Included

• 1,2, or three BearToad Molle Glock Magazine Holders
• Requires
  • 2 x HEX Nuts https://amzn.to/4p6Wkex (Also Found at Home Depot)
  • 2 x HEX Bolts https://amzn.to/4p6Wkex (Also Found at Home Depot)
  • 2 x Anchors from the EZ Molle System - https://makerworld.com/en/models/2164592 
  • 2 x Thumb Screws from the EZ Molle System - https://makerworld.com/en/models/2164592 

Print Settings

For safety and long-term retention strength, we recommend the following:

• Material: PETG or ASA (Recommended). Avoid standard PLA as it can creep/deform over time under the tension of the magazine.
• Wall Loops: 4 to 5 (Essential for maintaining the "spring" tension of the holder walls).
• Infill: 25-30% (Gyroid).
• Orientation: Print vertically for the smoothest internal draw surface.
• Supports: Tree supports are recommended for the mounting lugs only.

Reliability when it matters most. Welcome to the BearToad ecosystem.

Building out a full range setup? Pair this with our Molle EZ Clip and the EZ Shelf for your cleaning kit.

• Disclaimer: "Ensure all equipment is tested for fit and retention in a safe environment before use. BearToad is not responsible for equipment loss or accidents."

Feel Like helping out - Buy me a Coffee