Rainbow Six Siege Deimos’s Mask - Free 3D Print Model

Search models, users, collections, and posts

yorgadesigntr

Props & Cosplays>Masks & Helmets

IP Report

Print Profile(1)

All

H2S

P2S

X1 Carbon

P1S

H2C

X1E

H2D

P1P

H2D Pro

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

5.5 h

1 plate

5.0(3)

Open in Bambu Studio

Boost

140

101

Released

Description

This is Deimos’s mask from Rainbow Six Siege (a Ubisoft game).

I hope you like this design and support it ♥

Recommended print settings:
• 30% supports ♥

The story and description of the mask:

Description & Lore

Mask Description
Deimos’ mask is a cold and intimidating symbol of calculated chaos. Designed to erase identity and inspire fear, its sharp lines and hollow gaze reflect a mind driven by vengeance and control. The mask is not meant to protect the face — it is meant to become it.

Lore / Story
Once a shadow within the system, Deimos emerged as a reminder that betrayal leaves scars deeper than bullets. The mask represents his rejection of past loyalties and his transformation into a living weapon. Every time it is worn, it signals that Deimos is no longer a man bound by rules, but a force that hunts those who created him. In the world of Rainbow Six, the mask is a warning: the past always comes back.

LEGAL WARNING!
This 3D design is intended for artistic, cosplay, display, and collection purposes only.
Please do not use this design for illegal activities, impersonation, intimidation, or any action that may cause harm or violate the law.
The creator assumes no responsibility for misuse of this model.

Rainbow Six Siege and Deimos are trademarks of Ubisoft.
This is a fan-made, non-official 3D model.

THANK YOU SO MUCH ♥

Comment & Rating (10)

@yorgadesigntr

Pinned by Designer

LINK TO OTHER VERSION: https://makerworld.com/en/models/2235021-rainbow-six-siege-deimos-s-mask-v2#profileId-2432141

(Edited)

@kingdavidadams

Print Profile

0.2mm layer, 2 walls, 15% infill

so cool

@Sammos2828

printed it failed but that's most likely cause I paused it otherwise it was really good and sizing was perfect on the A1 mini

The designer has replied

@yorgadesigntr

why u paused it :D ? If the mask design is too large for the base, you can try cutting it in half and welding it together with a blowtorch. You can weld with a wind gun or blow torch, but don't forget to take precautions.