Silberthal Bio-waste Bin - Holder

I needed a replacement for my broken holder for the Silberthal bio-waste bin.

Therefore, I roughly looked at the distances and hole sizes and largely rebuilt it.

The component is very much focused on functionality rather than being oriented to the original holder. However, it is very robust. I have built in reinforcements on the hanging hook so that the printed part does not break easily there.

It is also advisable to print the part upright, otherwise, the individual print layers will be the weak point.

To save some material, one can certainly cut off up to the round holders using Bambu Studio.

But that will not be good for the load-bearing capacity.

I printed with PLA. PETG is certainly even better.

The hook has a spacing of approx 11mm. So the bin can be hung on doors that are 11mm thick.
If you have deeper doors, you can adjust this in the studio, or I will see if I can modify something.