[Dummy] Aimpoint Micro T2

This project is mostly for my enjoyment, any feedback is greatly appreciated, especially with the print configuration since I mostly created the model and commissioned someone else to print it, I have 0 other 3D printing knowledge.

-------------------------------------------------------------------------

This project is mostly for my enjoyment, any feedback is greatly appreciated, especially with the print configuration since I mostly created the model and commissioned someone else to print it, I have 0 other 3D printing knowledge.

A dummy model meant for decoration on model guns. The lens caps are flippable. You should be able to mount it on any Aimpoint T1/T2 pattern mounts.

Hardware needed if you intend to use this on a compatible mount (Use one of the 3 below):

• 4 M3x5/6mm screws to attach it to a compatible mount, or:
• Aimpoint T1/T2 compatible screws (real/airsoft), or:
• Superglue, if you don't intend to get the sight off the mount.

Some printers might struggle to print the cylindrical pins for the lens caps, in which case you can use whatever fits the length and diameter e.g. piece of filament wrapped in tape. 

-------------------------------------------------------------------------

I have a list of prints, mostly dummy optics/optic risers/optic mounts, that I can't really afford to print. If you're interested in testing the prints and sending me showcase photos then feel free to contact me, all files will be free of charge:

• Trijicon MRO + Trijicon 3X Magnifier
• Aimpoint magnifiers with LaRue flip to side mount
• Unity Tactical FAST Absolute+Accessory Risers
• ANVL UKON RMR mount for RMR pattern red dot sights
• Unity Tactical RAXIS for B.E Meyers MAWL laser
• Arisaka Low/2.26" Magnifier Mounts 
• Geissele 30mm scope mount
• Trijicon AccuPoint 1-6x24 LPVO
• ACR stock for A&K/DS/STS gel blasters