Huxley Techzone LM6UU x carriage (narrow)

Another lm6uu replacement carriage for the badly designed techzone x axis.

This one is narrow to keep 140+ mm of travel

It use only two LM6UU so make sure the zip tie are secured !

To use it you need to replace the imperial rods by 6mm rods and buy 2 LM6UU of course.

(it's up to you to replace the imperial by the 6mm, you may need to print new huxely part with 6mm hole instead of 6.35mm)

Don't forget to put a fan on it otherwise it will melt from the nozzle's heat(especially with PLA)

The pro are :

• identical mounting hole for nozzle as the original
• smoother movement against the "impossible to get aligned brass tube"
• better precision than "never correctly tighten bearings"
• simpler design
• fan mounting option
• asymmetrical design

The cons :

• only two lm6uu
• need a fan not taller than nozzle
• fan stream not optimized around nozzle.
• asymmetrical design

Be aware that you can print it in mirror like me to change the side of the belt clamp or put nozzle more left / right.

Print Settings

Printer:

Huxley techzone

Resolution:

Infill:

80%

Category: 3D Printer Parts