40K Necron hyperphase sword full scale

I hope this is going to be part of a full Necron costume, but for now I only have the Hyperphase sword, which is not even finished yet. I just wanted to post the files in case this project ends up in my project graveyard.

The full length is about 80cm.

I used two 15mm and one 23mm aluminim pipes for strength and bought a cheap-o thin LED strip to make the symbols illuminate. A few 18650 batteries fit perfectly in the handle and I made a small compartment for some electronics. The “blade” I made with foam and as you can see there's no pattern and/or lights in there YET. Since I did not actually print the blade its not prepared in printplate-sized parts.

I'm also working on the Staff of Light and a mask/helmet so hopefully they will be online soon.

Printed with a P1S.