4 Post Lift - For 1/10 RC Cars - Free 3D Print Model

Search models, users, collections, and posts

TheBasedDoge

Hobby & DIY>RC

IP Report

Print Profile(1)

All

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

5.8 h

2 plates

4.9(30)

Open in Bambu Studio

Boost

165

364

500

241

Released

Description

Simple 4 Post Lift for R/C Cars. The main tray is split in half to fit on the print bed, attaches with 4 bolts and holds up 1/10 scale RC cars.

Comment & Rating (46)

@user_510044140

Print Profile

0.2mm layer, 2 walls, 15% infill

printed first set of parts for the car lift perfectly. 3.5 hours using pla plus high speed

@catman25

Print Profile

0.2mm layer, 2 walls, 15% infill

loads my car up fine

@dre724

The print profile is no longer public

turned out great! even though I printed the same part twice so now it has ramps on both sides it still turned out good! no issues, great model!

@Raposo

Print Profile

0.2mm layer, 2 walls, 15% infill

ficou perfeito

@user_4253974899

i scaled it up to fit crawlers came out perfectly used petg to make more stronger

@Cobratuner

This is a completely different lift thats available here.

@user_3535738714

I am very satisfied great print

Show original

@FilthyCreations

Print Profile

0.2mm layer, 2 walls, 15% infill

came out awesome!

@Cobratuner

Isn’t the most friendly for 1/10 drift cars, but it’ll work. going to print and glue in place a little wheel stop for it since they’re riiight on the edge of falling off. Might give this one to a buddy and just size up the print a little too.

(Edited)

@sixty5low

Boosted

Great print! The hardware I used are as follows: Main tray - M4-.70 x 12 flat head socket cap screw with M4 nuts (4ea.) Post - M5-.80 x 25 button head socket cap screw with M5 nuts (4 ea.)

(Edited)