TISSUE CONTAINER BOX #1

Simple print of a container / box / case for tissues. In this version (#1) I haven't recreated any special decorations or writings (but if you want customizations, just ask and I'll gladly do them for you, like a dedication, a name, a phrase, a decoration, etc.).

It holds a box with dimensions 15.5 x 15.5 x 15.5 (cm), but to be safe, approximate to 15 x 15 x 15 cm.

If we then introduce the small drawer (optional and printable/downloadable on the second print bed, and for moving the container without dropping the box), the height of 15.5 cm is reduced to 13.5 cm (-2 cm). Inside it, common cube brands found in stores can be easily inserted (I calculated the maximum bulk of the largest one found at the supermarket). The drawer slides freely to prevent it from getting stuck over time.

Assembly is very simple (see uploaded images below):

Print Time: approx. 8:15 h // I did the best I could

Material Consumed: approx. 400 gr // I did the best I could

Material Used: PLA Silk Magic blue and purple (very beautiful and layers are less visible)

Supports: Standard supports inserted only where strictly necessary and as internal protection (they detach just by looking at them, don't worry).

Support Removal: low difficulty, but still pay attention, especially to those of the drawer housing.

Layer Height: 0.28 mm but it still presents with appreciable detail and is truly worth it

Infill Strength: 6%, but for its use and size / geometries, it holds up perfectly fine