Search models, users, collections, and posts

Open 6x17 V6 lens cone Graflex Optar 135 f4.7 lens

Remixed by

Print Profile(2)

All
A1
H2C
X1E
H2S
X1
H2D Pro
P1S
H2D
P2S
X1 Carbon
P1P
X2D
A2L

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
3.7 h
1 plate

m65 lenscone print profile 0.16mm layer, 2 walls, 15% infill
m65 lenscone print profile 0.16mm layer, 2 walls, 15% infill
Designer
6.5 h
1 plate

Open in Bambu Studio
Boost
3
13
2
1
7
1
Released 

Description

I've been getting asked questions about this lens cone on reddit and etsy by a few different people, which leads me to believe others would like to give this lens cone a try. I had the FFD marked down some place, but I've misplaced that and will have to confirm it again hence why I'm uploading this file. I will do some testing down the road to get the FFD again :)

 

I've tossed the fixed focus version and the m65 helicoid version up here.

 

Note: The fixed focus version will require you to make a hole in the lens cone to fit the little nub that sticks out of the graflex optar on its back side. I generally just attach the lens, jiggle it to mark where the nub sits - be mindful of the orientation of your lens at this point - and then drill a small hole through the lens cone. You'll want to light proof that some how, I generally use felt.

 

Good luck on your panoramic adventures. 

Boost Me (for free)

If this is helpful to you, consider boosting me!

Comment & Rating (2)

(0/1000)