Gargoyle dungeon book nook

Elevate your bookshelf with this book nook with a gargoyle protecting the entrance of your dungeon.
My initial idea was to use the electronic candle as it simulates a nice chandelier, however the fact its batteries and we have to keep to turn ON/OFF  is not very convenient if you want to keep it illuminated every day.
So i created some kind of shelf to use LED Lamp Kit  - MH001, you can even choose light strength by using the different levels and change colour by using a different diffusor. But RGB LED kits are now widely available too.

Print Setup:

• No need for supports, but make sure you have good bridge setup. (Flow, Speed)
• Use Arachne as it contains small lines.
• I left the base heavy so it holds the books but you can further reduce infill to save filament.
• LED adaptor is tight to hold it in place, insert half way if you're planning to remove it or change to diffusor.
• Electronic candles (usually are silicone) will go throw the little hole, make it facing backwards for a better chandelier effect.