Indoor fountain for humidification

Especially in winter, heated indoor air is usually very dry, which is not optimal for humans, animals, and plants

To counteract this, I developed this indoor fountain for air humidification

The water runs down a cone with a surface structure relatively quietly and releases moisture into the indoor air via the large wetted surface

An ultrasonic mister can also be used in the fountain, which then allows additional mist to trickle down over the cone

Of course, the fountain is also a beautiful eye-catcher on the flower bench or in the greenhouse ;-)

CAUTION: when using the mister, it should be noted that the area around the fountain will become damp due to the mist. This means that the fountain should only be placed on a moisture-insensitive surface

The print profile also includes three feet (which are connected to each other) so that the fountain stands slightly elevated due to the moisture

Required accessories:

• Mini water pump, for example: https://amzn.eu/d/jehVPr4
• Ultrasonic mister (this must have a maximum diameter of 48mm and a height of approx. 25mm), for example: https://amzn.eu/d/a24fXnT

If you have a mister with a greater height, you can use the taller pot from the attached print profile

Note on printing the bowl:

Since the water bowl needs to be watertight, it is important that the flow for the material used has been calibrated. The printing speed is slightly reduced to improve the bond of the individual layers (I have already set this in the print profile)

I recommend using PETG-HF

Have fun ;-)

© Staprin3D