Aquarium Snail Trap - simple with lid

Simple snail trap created with parametric model, cutting hole in Bambu studio and setting print without bottom or top layers (81% infill).

• Put cucumber on tooth pick, pin it inside trap into infill holes (or just throw some food snails prefer).
• Close it and throw it in aquarium (if floating, use some stones to weight it down).
• Theres edge so its harder for snails to get out. When pulling out - hole in lid should face up (so bottom part of lid doesnt let snails slide out).
• Shrimps should be okay to just swim away.

Tip: You can also add string through lid holes or put it around “bottom” thread - so its easier to pull up.

Print in PETG, dont use 3D lack or similar on base plate (could be harmful to aquarium creatures).

I have used this parametric model as base:

Powered by MakerWorld-Parametric Model Maker (https://makerworld.com/makerlab/parametricModelMaker)