minecraft steve no ams

Updated on 2026.3.25

Added handheld weapons (AMS required)

Added an arm for holding weapons

The arm has been updated in the minifigure file

There are two different arms, one of which has two 2x3mm openings for equipping weapons

Pay attention to the installation direction: the upward-facing one is for installing swords, pickaxes, crossbows, etc

The inward-facing one is for installing bows

==============================================

Updated on 2026.3.16

1. Adjusted the leg joints to solve the internal adhesion problem but they are a bit tighter than the earliest version
2. Adjusted all connections to be tighter, which can reduce the use of super glue However, as a keychain, it is still recommended to use super glue, otherwise, you might go out and come back with only the hair left
3. The 18cm Steve's joints have been adjusted to fit perfectly, so no super glue is needed for playing with it
4. Added a separate print profile for the head joint, which improves printing results (for the 18cm Steve's separate head, an additional plate is added to the print profile, please print as needed)
5. Reinforced the Print in Place head joint (although it can also be printed separately, a major feature of 3D printing is the ability to print movable joints as a single piece, so I still prefer the Print in Place version)

==============================================

Minecraft Steve 8cm tall

He shares a body with the Zombie

The joints need to be pushed inwards and held, then gently rotated

There are holes for hanging as a keychain

Because the minifigure is very small, some details may vary due to differences in printer and filament

May require some slight trimming or sanding

Hope you all like it