[Sailor Uniform Series] Classic Red Bow Tie Small Square Bag Sailor Moon Style JK Uniform Crossbody Bag No AMS Assembly JK Ita Bag Must-have for girls

📖 Product Introduction / Introduction

This version is specially designed for female 3D printing enthusiasts, whether you have an AMS multi-color system or not, you can easily print this perfectly color-separated Sailor Moon style JK bag!

With a clever split design, you can print parts of different colors separately using a single-color printer, and then complete the assembly with buckles and a small amount of glue. This method not only saves waste from multi-color changes but also allows for high customization by changing filament colors.

🛠️ Print Instructions / Print Settings (Optimized for Single Extruder)

• Color Printing Suggestions：
  • White parts：Bag body (Body)
  • Blue parts：Bag flap (Flap)
  • Red parts：3D bow (Bow)
  • Gold parts：Central decorative round buckle
• Filament selection：Recommended to use PLA, the full set of Bambu Lab official colors or Caidowu 99 Gold. A piece of filament needs to be threaded into the connection at the back of the bag to enable the bag to open and close.
• Support suggestions：All parts are optimized, basically no supports (Support-Free) or only require very little support, greatly reducing the printing difficulty.

🔧 Assembly Guide / Assembly Instructions

To ensure structural stability, please follow these steps:

1. Clean the buckles：After printing, check and clean any fine stringing at the buckle points to ensure precise fitting.
2. Buckle connection：Connect the blue flap to the white bag body through the reserved buckles, using filament to thread them together for assembly.
3. Glue reinforcement：Apply a small amount of 401 glue or B7000 glue to the back of the bow and the central round buckle, and press to secure for 30 seconds.
4. Accessory installation：Standard 4mm holes are reserved on the side for attaching Luna Cat pendants and commercially available metal shoulder strap buckles.

✨ Why choose this version? / Why download this?

• Zero waste：Compared to frequent filament changes with AMS, this split-part solution generates almost no waste (Poop).
• Smoother：Since each part can be arranged in the optimal direction, the surface layer texture will be finer.
• Beginner-friendly：Greatly reduces the common risks of color bleeding or nozzle clogs in multi-color printing.