Search models, users, collections, and posts
Liter Scoop
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
4.9 h
1 plate
Open in Bambu Studio
Boost
1
4
0
0
10
6
Released
Description
The scoop capacity is approximately 1 liter. I printed it using a P2S with PLA Basic filament. I printed it with 3 wall loops and 15% infill using the Gyroid pattern. When printed with in the orientation with the open end up, you should not need to use any supports. The angles on the handle were designed so that supports are NOT required. Of course, you can add supports if you want to added.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)