Desk Top Trash Can or Storage Bin in Vase Mode

This is a solid model intended to be printed in vase mode. The profile I uploaded uses a 0.4mm nozzle with an outer wall extrusion width of .55mm, which is wider than normal. Layer adhesion is important for a print like this, so I highly recommend printing with a higher than normal nozzle temperature. I simply create a copy of the filament profile that I would normally use, and adjust the "other layer" nozzle temp 10 or 15 degrees higher than the default. You can go as high as the upper limit printed on the side of the spool.

I also recommend waiting for the print to cool before removing it from the build plate. The connection between the walls of the print and the base is a little bit fragile, so you don't want to stress that by removing it too soon. The default size is 100mm X 100mm X 120mm.