SCX30 - Jeep Rubicon Fastback Conversion
Print Profile(2)
Description
Have you ever looked at your SCX30 Jeep Rubicon and thought “Gee, I wish the rear was angled”? Now it's possible!
Simply mark and cut out the existing body line following the rear doors and trunk section. The new fastback part will clip into the body with the supplied tabs, then secure in place with the roof rack section. When installing screws, either use a small washer or use a screw with a head larger than the diameter of the peg insert.
Layer lines are set to 0.16mm but can be lowered for higher resolution. The roof rack is printed with supports, but can be flipped for filament savings at the cost of the build plate texture showing outwards.
Feel free to drop a message if you have any questions!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (20)