Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
50 min
1 plate
Open in Bambu Studio
Boost
3
10
0
1
1
1
Released
Description
Drop-in replacements for the Sega Saturn CD drive standoffs. This model does not have the snap in tabs at the bottom as those would cause issues with FDM printing, and they are not needed because the M3 screws properly center them. Your drive should fit slightly loose with some wiggle on the rubber grommets, this is normal, the OE standoffs do the same.
Printing:
No supports needed. Use PETG, do not use PLA.
Assembly:
Use (4) of M3x10 screws.
Materials:
Revision Log:
Rev0 - Initial release
Note: Amazon links are affiliates.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)