Misfits Legacy Of Brutality Hueforge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 199x200mm in size
You may print at higher layer heights below the Base Thickness of 0.64mm
The Max allowed Thickness is 2.4mm and the Actual Thickness is 2.38993mm

Filaments Used:
    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
    #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 6
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #12 (1.04mm) swap to Red
    At layer #16 (1.36mm) swap to Yellow

Border Only Colors from here until the end.
    At layer #19 (1.6mm) swap to Jade White for the rest.