Nine-Ring Monk's Staff [Assembly Model]

Journey to the West: Nine-Ring Monk's Staff

Assembly Model

When assembling, first place the rings below the streamers, then insert the streamers into the main shaft. There are nine rings; hang them in a single-double-single-double-single-double order, with single rings on the lower layer and double rings on the middle layer. You can refer to my second display image above for details.

Two versions:

Mini version: The staff head is about 80mm high, and the parts are relatively small. Although reinforced, printing with silk filament will still be quite brittle, so be very careful not to break it when removing supports and installing. The mini version cannot be directly assembled without adhesive during installation; a little glue is needed to fix it.

Normal size version: The staff head is about 240mm high and can be fitted onto a 25mm PVC pipe. The print profile also includes a 25mm staff shaft model: one end piece and one connecting piece, both 20cm long. You can print multiple connecting pieces as needed to combine them into your desired length. The staff head can be directly assembled. The base sleeve is relatively large and will tip over if placed directly; you can stuff some paper around the rod to secure it.