Search models, users, collections, and posts
Swim Goggle Nose pieces (Tyr/Speed/Generic)
Remixed by
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
33 min
2 plates
Open in Bambu Studio
Boost
4
17
2
0
28
17
Released
Description
- Took a basic nosepiece blueprint and made several modifications to fit my Speed Vanquisher and Tyr Velocity swim goggles using my head size.
- Created some generic sized nose pieces for others who may have different width of eyes.
- One of the models was left in generic form in case it needs to be modified and the 4 generic models I published don't fit.
- Recommend TPU for the Generic and Velocity versions.
- Recommend PETG for the Vanquisher model.
- Did NOT try PLA but you can give it a try.
My infill was kept standard and they seem to work thus far for my use. If you have any failure you may raise the infill % to make them sturdier.
Note: Its possible you may need to make small sizing tweaks based on your printer's tolerances. These are small objects to they could vary by a few tenths of a millimeter once printed. Don't hesitate to reach out if any questions.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)