Print Profile(1)
Description
Finally, a camera mount with low filament consumption and great flexibility!
I was looking for a baby monitor mount that uses little filament for a long time. Most of the ones I found used > 60g filament! For this reason, I designed my own mount and provided all the components. If you even find these at home in your workshop (M6x8 hex screw, M6 nut), you even save over 50% filament compared to most mounts!
The camera is clamped by the ring, as it has a smaller opening angle. The upper and lower parts are held together by a nut and screw.
The flexibility of the mount is ensured by the M12 screw, allowing for an edge width of 31.9mm.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)