Narrow blade holder for HORL sharpener

The Horl holder of the “cruise 2” model does not allow small blades to be sharpened.

I therefore propose this model for sharpening both narrow and wide blades.

4 modifications compared to the original holder:

1— Much stronger attachment

2— Wider support (70 mm instead of 57 mm)

3— Supports both wide and narrow blades

4— Notching on the wedge for better blade retention

Provide four 8x15x5 magnets

 https://www.123-magnet.com/cat-aimant-n-odyme-303.htm 

Assembly :

Mark the magnets as shown in the photo and glue them in place, respecting this marking (you'll see, it's fun to try to impose your will on a magnet) beware of the risk of biting.

If you cannot print “HSPC-ProtectionPetite X2 and HSPC-Protection Grande” in FLEX, stick on a strip of fabric adhesive.

The stud locations on the wedge are tighter than on the body to remain on the wedge, if necessary, glue them into the wedge.

Voilà