iPhone Holder SmartForTwo car

iPhone holder with MagSafe PUK for a SMART ForTwo, to be mounted on the side of the display, on the outer right

• MagSafe Charger (PUK = 56mm x 6mm) additionally required (see below)
• Depending on print quality, the charging puck may need to be glued in (double-sided adhesive tape or silicone/glue for permanent hold)

Print in **PETG** at **minimum**, *ASA or ABS is better* to ensure heat resistance in summer

• Print position: Upside down recommended
• Support structure (tree) recommended
• Infill 10 - 15% in Gyroid recommended

Tested with iPhone 13 mini & iPhone 16 // I only use it in portrait mode

Mounting: Yes, the holder is screwed to the side of the display

→ **Do not use screws that are too long** to avoid damage inside the display

I used the following:

• Screws: L: 17mm x Ø: 3.5 mm + Screw head Ø max. 8mm (Screw type e.g. Spax (Self-Drilling / -Tapping)
• Black screws for a better look

I used the following parts for my conversion: **These are AMAZON affiliate links!**

Wireless charger / MagSafe PUK connected e.g. to cigarette lighter or existing USB socket

• MagSafe Charging Puck: https://amzn.to/3YYec0j

I neatly routed the cable behind the trim panels downwards and to the center console. I needed the following parts:

• USB-C cable extension angled: https://amzn.to/4szmjy8
• USB-C Cigarette Lighter Adapter: https://amzn.to/4pv5guq

Alternative for connecting to the original USB-A socket: Adapter USB A - USB C = https://amzn.to/49rSIh8 (lower charging power!)