Mikowl

cover

PXL_20230925_230325639.jpg

PXL_20230925_230255647.jpg

plate_1.png

PXL_20230925_230339964.webp

PXL_20230925_230325639.webp

PXL_20230925_230255647.webp

Printed with the standard Bambu PLA Basic settings takes about 8 minutes to print 1.&nbsp;I up the infil to 20% gyroid and left everything else as is!

0.2mm layer, 2 walls, 20% infill

s_7eb5b360-c0c2-4c52-99e4-91805a453e43.webp

plate_1.webp

This profile uses less filament and takes less time per hook.<ul><li>Replaced sparse infill with walls. Theoretically this increases strength. There wasn't much infill to replace so this represents a very modest increase in filament.</li><li>Width reduced from 10mm to 5mm. This reduces the amount of filament used, decreases print time, and is of comparable  strength to 10mm with 15% infill and 10mm with 100% infill (I tested both). The 10mm does however tend to swivel less if that's of concern to your intended use. Layer height increased - there are no fine details and this decreases print time ever so slightly.</li></ul>

PETG x6 at 0.28mm layer, 6 walls, 100% infill

Accurate 3D Services

IMG_4546_dce964ab-9eba-4719-9eaa-0a260eb7f894.webp

PETG Recommended, however the profile is set up for PLA, ABS/ASA as well with the addition of a brim, and slight scaling of the model size.&nbsp;

All Bambu Printers - 0.2mm layer, 6 walls, 20% infill

I needed something that was quick and easy to print to organize my workshop. So I whipped these up and they work great. They hold a moderate amount of weight and pictured they are printed in PLA. Recently created a 120mm x 120mm x 100mm box that work with these hooks. <a target="_blank" href="https://makerworld.com/en/models/42370#profileId-43163" rel="nofollow noopener">Hanging Storage Box</a>

S Hook

Bart_,_

Zrzut ekranu 2025-07-02 102537.png

S hook

MightyMax

IMG_0726.jpg

S Hook with stop

ASIA

Print Profile(3)

Description

Comment & Rating (880)

License

Remixes (3)

Related Models