1.9 "LOADED" Comp Lock Bead Lock Crawler Wheels

Here is the weighted version of my 1.9 competition bead lock wheels. I designed these with the intention of creating a well polished, strong and aesthetically pleasing 3D printed bead lock wheel. The addition of un-sprung weight will further enhance your crawlers ability to overcome challenging obstacles.

• Note - This is the revolver version of my weighted 1.9 wheels. These wheels capture the bearings from the back side of the barrel, leaving the front exposed for aesthetics. Model specific revolver face plate. Compatible with 1.9 comp OS/NOS wheel faces.

Features:

• Ability to easily add/remove weight from wheels.
• Accepts ½ or 12.7mm bearings/balls.  Steel > Brass > Tungsten
• Securely captures bearings with tight tolerances
• Deep bead lock groove to accept any 1.9 tire bead
• Smooth inner bead lock barrels
• Reinforced holes for strong bead clamping
• Drainage channels on the back for use in wet/damp conditions
• Model specific revolver face plate
• Compatible with the 1.9 comp face plate
• Fully rebuildable

Recommendations:

• Plates are preset for a set of (2) wheels. Add/Delete items as needed.
• Brim is highly recommended for the bead lock bodies. The brim has been preset so don't forget to remove the brim from the faces and rear bead lock ring before printing.
• Textured plate is highly recommended for the bead lock bodies as smooth plates allow the model to lift and lose alignment. 
• I have tested a few hubs, vanquish, probuild, amazon, etc. I've had no issues with hub diameter clearance. However, maximum hub diameter is < 22.50mm.
• Recommended hub length is .725 / .850 +

Bill of Materials:

• (12) M3 x 10mm per wheel - These are for the bead lock ring and face plate
• (6) M3 x 8mm per wheel - These are for the rear bearing capture plate
• (6) ½ or 12.7mm bearings/balls per wheel. Steel, Brass or Tungsten.

This is a personal model/file and is not to be distributed or sold in any way without my written consent. Thank you and I hope you enjoy!