Snap In Wall Hanger for Pipes
Print Profile(1)
Description
Original design was for the 75mm pipe hanger that I designed and printed to hang my BMW Overpipe (~7-10lb) in my garage bathroom as a display piece which have been holding strong for over a year and was printed with basic PLA. This hangers are designed specifically to hold pipes that have irregular shapes and curves. The hangers have a bit of flex in them so you can push the pipes in and they can snap around the pipe. The Hangers are designed to face up so the weight of the pipe pushes the pipe down into the hanger and can't fall out overtime as the filament begins to stretch, so there is a right and wrong way to install them, make sure to double check that when installing. Other variants of this hangers (34, 50, 67.5 mm) have not been tested so use at your own risk.
The model can be printed without any supports. Its designed for use with screws that you have to screw into the wall or another surface where you are trying to secure the hangers to.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)