Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
4.5 h
1 plate
Open in Bambu Studio
Boost
22
87
2
1
85
48
Released
Description
Replacement feet for airers - no more robot vacuums stuck on them
I designed it to fit on the most drying racks with 16mm tubes. Tested on Leifheit and vileda airers - perfect fit
If your robot vacuum keeps getting stuck on your airer, these raised replacement feet are a clean and aesthetic solution. Instead of adding barriers and other extra plastic parts, these feet replace the original ones. It adds extra height while keeping factory-look.
Easy print: PLA or PETG, no supports, no brim. 15% infill is more than enough.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)