No Support Toploader Badge Holder w/ Chamfer (PLA)
Print Profile(1)
Description
This Toploader Badge Holder doesn’t need supports. Quick prints with clean results. Great to use to display your cards at card shows.
Fits 35 pt Toploader
Dimensions:
3D Print Holder Dimensions: 83.4 x 112.75 x6 mm
They are the same size, only difference is the hole size. One was made for the retractable badge holders which can be clipped on your belt. The other one is for the lanyard style of badge holders.
Lanyard Measurements I used:
Braided Cord is 457.2 mm long
Metal Holder is approximately 50.8 mm
The retractable Badge Holder is just the standard size.
Note: If your toploader is too loose, just reduce the width of the holder by 0.15mm. I tested two generic toploaders and they were perfectly fit, but there are a variety of toploaders out there.
Instructions
1. Place 35pt card in penny sleeve.
2. Load this into your 35 pt toploader.
3. From the top, slide your toploader into the 3D printed holder.
4. Lock your lanyard clip into the rectangular hole at the top center of the 3D printed holder.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)