Search models, users, collections, and posts
510 Holder with Angle
IP Report
Print Profile(1)
0.15mm layer, 2 walls, 15% infill
Designer
50 min
1 plate
Open in Bambu Studio
Boost
26
94
5
1
75
56
Released
Description
Here it is folks!
The 510 vape holder I have needed my whole life (so you probably do too)
Complete with three slots for cartridges to stand vertical - and a 10 degree angled slot for those sweet last few drops of juice to collect at the bottom. IYKYK.
Check out my other 510 print - Strain ID Bands
Only uses 12g of PLA.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (5)