"Drops" Deck Box | Pokemon, Magic and Lorcana

Remember to read the model's license! The Standard Digital File file forbids SELLING, REMIXING and REDISTRIBUTING models!

Want to sell this model? The only legal and safe waya to obtain a commercial license are through my Patreon or via Makerworld Commercial License. Please join to know more. You can also support me, join our Patreon chat and learn more about what I am doing. With a Patreon membership, you'll also be able to participate in giveaways and send me private customisation requests!

🔍 Please read the model description fully before printing!

This minimal deck box uses simple curves and pleasing color separation for a very straightforward and generally usable aesthetics. It uses a compliant flexible hinge with a small pin to hold the lid in place

Cards

This deck box fits 60, 80 or 100 single-sleeved standard 88 mm x 63 mm cards. This is the default format for Magic: the Gathering, Lorcana and Pokemon cards. Sleeves are slightly larger than the card themselves, usually around 90mm x 65mm. The empty volume inside this deck box is the following (by size):

• 60 cards → 42mm deep, 95mm tall, 70mm wide
• 80 cards → 58mm deep, 95mm tall, 70mm wide
• 100 cards → 70mm deep, 95mm tall, 70mm wide

Printing instructions

Highly advised. Adding a brim to the base of each deck box - if you are printing in a cold or drafty room, and/or with a non-enclosed printer, especially during winter. I had warping with the magenta lid (where I did not use a brim), but the orange lid was perfect (where I used a brim).

Ironing. Disabled in the provided profile, but can be useful for a more uniform surface on each drop.

Hinge. The bottom of each side hinge may be slightly deformed depending on the filament you are using and the overhang speed. That is not an issue. However, I obtained better results with PLA Basic. PETG-HF also advised for extra flexibility (although it may deform on the long run).

Tolerances and clearances

• It is impossible to design for all filament types
• My models are designed and printed using Bambu Lab printers and Bambu Lab filaments
• If you use other filament types (different materials) or vendors (different brand), the result may differ. Before posting issues about tolerances / model tightness / loseness, please consider the filament you used for the print.
• Even with the same filament, results may vary (different settings, humidity, ventilation, etc…)

Common print troubleshooting

• Adhesion. Ensure you clean your print bed regularly with quality dish soap and water. Use of a releasing agent like Magigoo is advised. This advice is only applicable to PEI plates. Please consult your build plate manufacturer for detailed cleaning instructions! If you still have adhesion issues, try using a Super Tack or a BIQU cool plate; or add an extra brim to the model.
• Material. My prints are all PLA. Use other materials at your own risk. You will likely need to tune the printing profile.
• Temperature. Cold air and drafts can lower the quality of the print. Ensure your printer is located in an environment with stable temperature.
• Drying. Drying PLA is not a requirement, but be aware that over-drying can cause layer detachment.