DP_Rolife_SuperCreator_RoofSystem

Custom Roof Assembly for Rolife BookNook Super Creator DIY Kits

The roof rafters/frame has a spot to press fit the included overhead light with each kit. You will also need to press fit the corner post into the frame.  It does need supports to print unfortunately - I had to use side cutters on the middle section to properly remove the supports.

There is a post hole on one corner and one of the slots for the walls needs to have a support removed as well. I opted to run the light connection through one of the wall slots and back the outside of the wall as the instructions with the kit suggested. 

The shingled roof is printed on its side. I printed on my x1c at quiet mode to reduce shaking of my setup. Came out great first time. I also turned the aux fan down to 50% since you don't really need it. This section will fit onto the roof rafters/frame and has a side that press fits into it. This keeps it from sliding around or falling off if bumped. No supports needed at all for this one.