Medieval Fantasy (Dark Souls) Style Knight Master

I have only tried PETG. PLA might not be flexible enough, making it difficult to insert the belt, so PETG printing is recommended

This is a work I haphazardly made when I was learning game modeling. Looking back, it's a bit too abstract, haha. It's perfect for learning how to convert game models into 3D printed objects

The size is the largest my A1 mini can print. It's a bit of waste if it's too big. I used 0.12 for accuracy, and the PETG_HF I used produced quite good results

It's a relatively simple shape with basically no installation bottlenecks. Just use super glue and you're done

The installation diagram is below. Pay a little attention to the belt part. I will introduce the installation method in Figure 2

Figure 1👇 Overall installation

Note: The two egg-like parts I drew on the lower body need super glue to connect the two small belts

Figure 2 Belt installation👇

You need to use your excellent technique to directly insert the belt into the upper body, then just apply super glue to the two protrusions and it's OK

For the three straps above, install the belt first and then hang them directly. You can glue them or not, generally they won't fall off

Finally, thank you all for your patient reading and printing. I hope you like my model. If you don't like it, I'll kowtow and apologize to you

If any master takes the time to paint it, I hope you can leave photos in the comment section so I can enjoy them too. Thank you 🙏