Search models, users, collections, and posts
CordMate II coupler
Remixed by
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Open in Bambu Studio
Boost
2
3
2
0
8
3
Released
Description
I needed an additional coupler for my wall-mounted Cordmate installation, and I didn't feel like driving to Home Depot for a $2 part. I found this coupler with a screw-in mount which was close to what I needed. I didn't need the screw-in mount, though, so I used TinkerCAD to remove it.
This is my first remix, so it was also a learning exercise for me. It's not a perfectly clean modification as I couldn't get TinkerCAD to fully remove the part closest to the coupler. I don't think you would notice it without getting up close to the wall.
I used Bambu Matte Ivory White PLA, 0.24mm draft mode.
Photos show the printed model with the original CordMate II coupler next to it.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)