Search models, users, collections, and posts
Carpuride W603 Quadlock mount
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
29
74
5
3
123
66
Released
Description
This is a Quad Lock back plate adaptor for Carpuride W603 . Just remove the original plate ( 4 screws ) and replace with this one.
I printed in ABS and seems to be holding just fine ( should be ok with PETG or tough PLA ).
The design is tight enough but for a 100% waterproof setup I woudl advise a very light line of silicone around the plate ( the original doesn't have any and I doubt any water will filter through anyway )
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (5)