ECOVACS DEEBOT T50 PRO Omni Dust Bin

Reusable dustbin for the ECOVACS DEEBOT T50 Pro Omni that lets you ditch disposable bags and keep using the powerful 300 ml internal dustbin capacity of the robot.

Product overview

This 3D printable dustbin replaces the disposable bag system with a reusable container that fits into the OMNI station for the DEEBOT T50 Pro Omni series.
It is designed for easy printing, simple assembly and day‑to‑day use in a busy household.

Key features

• Designed specifically for ECOVACS DEEBOT T50 Pro Omni docking station geometry.
• Integrated holder for the original ECOVACS filter so you can keep using OEM filtration.
• Optional DIY filter slot for self‑made filter media (e.g. non‑woven, HEPA sheet, fabric) to fine‑tune filtration and costs.
• Snap‑fit lid for quick emptying and secure closure during auto‑empty cycles.
• All main parts join with a small dab of superglue for a rigid, long‑lasting assembly.
• Simple hinge that is pinned using two short pieces of 1.75 mm filament, no extra hardware required.

Printing recommendations

• Print all parts in PETG or ABS/ASA for better heat and wear resistance inside the station.
• Use 0.2 mm layer height, at least 3 perimeters and 20–30% infill for durability and airtightness.
• Supports are usually only needed for the filter holder overhangs, depending on printer and orientation.

Assembly notes

• Dry‑fit all pieces first, then fix permanently with small drops of superglue on the mating surfaces.
• Use two short, straight pieces of filament as hinge pins and push them through the hinge loops until fully seated.
• Install the original filter (or DIY filter) into the holder, close the snap lid, and place the bin into the OMNI station as you would the original bag container.

Usage & maintenance

• Empty the bin regularly and check the filter for dust buildup to maintain suction performance.
• Replace or clean the optional DIY filter media as needed; do not run the system without a filter to protect the robot and station.