Arc Raiders Keycap (Needs AMS)

Arc Raiders logo key cap, uses 5 colors so you have to do a swap in your ams after the first color, its pretty simple as long as you set it up right. Basically the red gets mapped to the same slot in the ams as the blue, and after its done with the blue you just pull it from the ams and put the red in that slot. After that you can just leave it.

Print takes about 30mins, I have the second layer set to all yellow just to reduce the wast, makes them all come out a bit brighter without doing another 4 changes (and another manual change), a single layer of the colors was a bit too dull.

Example was printed with bambu filaments, blue should have been a lighter shade, but its what I had.

Should be set up like this:

think this is the default order anyway, but better safe than sorry.

Important bit is to map the red to the same slot as blue, so you can change it out