Escape from Duckov Figurine Ornament
Print Profile(3)
Bill of Materials
Description
01.06 After being reminded by netizens, a configuration issue with embedded magnets in the weapon pause was found, re-uploaded
The following is the original text~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Escape From Duckov Figurine
The little yellow duck figurine I made before is now open source. The main body is about 10*5cm, with a full set of magnetic attachments: including helmet, bulletproof vest, rifle, backpack, and poop, all of which are removable.
Note: This project requires a large number of magnets or magnetic beads (two 6*2 magnets, eleven 4*2 magnets, and one 4mm magnetic bead are needed), n52 specification is recommended
About Embedded Magnets:
1. A print pause is set on the main body's forehead for a 6*2 round magnet, and its magnetic polarity needs to match the helmet
2. The basic weapon also has a pause setting for embedded magnets, embed a 4*2 round magnet, and its magnetic polarity needs to match the magnet on the wing
3. Additionally, a magnetic bead (or Buckyball) needs to be placed inside the poop prop and the small grenade, then reassembled, allowing them to attach freely
4. Soft rubber connectors are recommended to be printed using TPU
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (16)