DJI Air3s and OSMO Pocket Case

I created this case to hold my photography gear as listed below.

To assemble the lid, center, bottom, and handle I used 6x 10-penny nails 3.4mm shaft diameter cut to 35mm long which slide right in with no adhesive, and shouldn't come loose. I've included the Bambu equivalent, which you may need to glue on the ends given the diameter is slightly less.

Storage for the following:

DJI Air3S Fly More Combo Kit-

• 2x sets of propellers
• ND filter case
• wide angle filter case
• 3x battery case
• Air3S
• RC 2 controller

DJI Osmo Pocket 3 Combo Kit-

• Pocket 3
• Pocket 3 tripod
• Pocket 3 extended external battery
• Mic 2 with wind buffer

Additionally-

• SD Card Reader
• Square Card Reader
• Start RC or similar night fly lights
• GAN Charger
• Charging cord

The photos are of revision 2, the model is now officially revision 3 which changed around the orientation of some objects stored inside to make them safer, and add blocks/buffers on the lid so that things don't shift when you open it to get to the drone.

I've used this on numerous shoots and it's very convenient. One such shoot was offroad where our EcoFlow Delta Pro bounced up and onto the case. Printed in PETG everything inside survived.