P2S Gridfinity Vented Side Riser

Gridfinity riser for the side of the P2S that retains airflow to the air vent.  I think of it as a “sidecar” for your P2S.  This riser prints in three interlocking parts and stays in place by going around the anti-vibration feet (the side of the P2S is not magnetic, so you can't use magnets).  Gridfinity grid is 9U (L) x 2U (W) and has magnet holes for 6mmx2mm magnets, should you choose to use them.  The area around the air vent is slightly oversized to provide more than adequate airflow.  

The print profile contains all of the parts individually, and one plate with everything.  You may choose to print three plates or just one. Personally, I like to print large parts separately to minimize the time on the printer and therefore minimize the risk of warping.  

For the bridge piece, there is a chamfer (angled area) on the bottom on one side, that side goes against the printer.  Also note that the bridge prints with brims on the corners to help prevent warping.  When installing, I found it easiest to open the door and lift the printer by the top corner.

If you print this, post a photo, I would love to see your print.  And please rate the profile.