Samsung Galaxy A15 Phone Case

NEW!!!! TPU PRINT PROFILE AVAILABLE!!!!!

IMPORTANT! READ BEFORE PRINTING

This is a precision-fit phone case designed for a clean look, smooth curves, and snug protection. It’s modeled to wrap tightly around the phone for a secure feel, which means material choice and print settings matter for a successful print.

Material Requirement

This case is strongly recommended to be printed in TPU. TPU gives the flexibility needed for a proper fit and easy installation and removal.

⚠️ PLA WARNING
PLA will technically print, but the fit will be extremely tight. In testing, removing the case from the phone required force and may damage the print. If you print in PLA, be aware that you may need to break the case to remove it.

Print Profile Notes

• Print speed: Do not exceed 100% speed
• Walls/Perimeters: 3–4 for strength
• Infill: 15–20%
• Supports: Enabled where required
• You may need pliers to remove the supports carefully

The case prints flat on the build plate for accuracy, and the rounded edges help reduce warping while keeping the design comfortable in hand. Slower outer walls and flexible filament will give the best surface finish and fit.

Heads-Up

This model was part of a recent design sprint, so thank you for your patience. If support removal or fit feels tighter than expected, I’m planning to release an updated profile with improved tolerances if needed. I can answer any requests or questions in the comment section below or at 435-301-5505.