Search models, users, collections, and posts
Harry Potter Wax Stamps
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
2 plates
Open in Bambu Studio
Boost
56
223
7
0
167
103
Released
Description
Remixed this from Anheba's model so I could adapt it to other uses. It has an option for elevated or recessed Harry Potter initials.
For best results (I used colored glue from a glue gun) Melt the glue and press the stamp into the hot glue. LEAVE IT IN PLACE until the glue has dried 1-2 minutes then it will easily lift off without ruining the stamp.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)