Search models, users, collections, and posts
Roof 3x3 - DungeonBlocks
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6 h
1 plate
Open in Bambu Studio
Boost
54
199
3
1
121
24
Released
Description
I wanted a solitary roof that was simpler and easy to remove from the DungeonBlocks medieval pack when making a small tudor style house. The DungeonBlocks center tall roof piece was also giving me trouble when printing.
This is my solution. A single printable roof that will fit a 3x3 DungeonBlock medieval house. This is a lot easier to remove so that you dont have to remove every single roof piece one by one. This is also shorter height-wise making it look a little less funky IMO.
(Picture shows a concentric first layer. Printed at 0.2 layer height)
No Supports needed. Model is internally supported. I recommend 15-20% infill. Fits in with other DungeonBlocks and original grid.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)