M12 adapter w/ mounting flange thru wires template
Print Profile(1)
Description
Milwaukee M12 battery adapter.
-Mounting flange with inset for #10 hardware (I used 10-24). Flange is designed to be bolted from the inside, but I'm sure you could work hardware in from the outside if you wanted to.
-Through mount wiring. (I included a template in the print profile for drilling mounting holes and wiring pass through.
-#6-32X1/2" screws for backing plate.
NOTE: When assembling, I prepare the wires with spade connectors (no insulation on the connectors.) Install the spades into the adapter, and press a battery pack into the adapter to ensure spade alignment. Then I fill the end cap with silicone, and install. Leave the battery installed until the silicone sets. (Ensure your wires are taped and separated!)
This is a heavily modified remix of Doublec4's m12-makita adapter. Link: https://www.thingiverse.com/thing:4239972
Enjoy!
Original item was remixed in the following ways:
- Added mounting flange
- Created back plate
- Changed hardware configuration
- Multiple other tweaks
- Created drill template
Boost Me (for free)
If this was a good solution for you, drop a boost!
This remix is based on
License
Comment & Rating (6)