Carpuride W502 adapter for Garmin Zumo mounts

Carpuride W502 adapter for Garmin Zumo (XT, XT2, Tread, Tread2) motorcycle mounts

Since I sometimes want to use my Carpuride in addition to my Garmin navigation system without having to mount an extra holder on my motorcycle, I designed this adapter.

The adapter does not have a power supply; I use the original Carpuride cable for this.

Next to the adapter, there is a TPU seal on the second plate.

Longer screws are required to attach the adapter. The original screws are too short.

I use the following: M3x12mm.

Only tighten the screws by hand so as not to damage the adapter.

I have been using the adapter again for about 10 months. I have experimented a lot with different filaments.

I have had the best experience with ASA. ABS certainly works very well too!

Normal PLA is not suitable. PETG probably works, but I always use the original ASA from Bambu Lab for such parts.

I have had good experiences with it so far in terms of durability.

PETG-CF was not break-proof; normal PETG was more stable. But if you want to be on the safe side, you should use ASA, ABS, or a similarly stable and weather-resistant filament.

Another variant for the Carpuride W702 is also available in my profile.

!!!Use of the adapter is at your own risk!!!

Please note the Makerworld license!

All my models are published under the MakerWorld Standard License for digital files and are intended for personal use only. Selling and/or offering them under your own name, including on other platforms, is expressly prohibited!