Aang Avatar State
Print Profile(1)
Bill of Materials
Description
**IMPORTANT INFORMATION**
You cannot adjust the z scaling on any hueforge. This will mess with the coloring done and your hueforge will not come out as intended. You can however change the x and y to scale the picture. I recommend only changing by the same percentage.
To get an accurate print as shown in the photos you MUST use the same filaments listed below. You can change brands (as long as they are similar) but keep the filament colors the same. If you use any other color, you will not get the same results as me.
What you see in the slicer will not be how the final results will look! Hueforge takes advantage of color bleed to make the blended colors!
I have added pauses for color swaps for those with only one ams!!
If you enjoy my work or are looking for something different, consider joining my Patreon! I upload all my files there and offer different membership tiers.
www.patreon.com/MonkeyForge3D
Project: Anng avatar state.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 188x235mm in size
You may print at higher layer heights below the Base Thickness of 0.96mm
The Max allowed Thickness is 3.92mm and the Actual Thickness is 3.52mm
Filaments Used:
#000000 PLA BambuLab Basic Black Transmission Distance: 0.6
#9d432c PLA BambuLab Basic Brown Transmission Distance: 2
#ff6a13 PLA BambuLab Basic Orange Transmission Distance: 4.4
#0086d6 PLA BambuLab Basic Cyan Transmission Distance: 3.5
#fce300 PLA BambuLab Basic Yellow Transmission Distance: 6
#e8dbb7 PLA BambuLab Matte Desert Tan Transmission Distance: 1
#56b7e6 PLA BambuLab Matte Sky Blue Transmission Distance: 1.3
#ffffff PLA BambuLab Matte Ivory White Transmission Distance: 3.5
This print uses 8 unique filaments
Swap Instructions:
Start with Black
At layer #18 (1.52mm) swap to Brown
At layer #20 (1.68mm) swap to Orange
At layer #22 (1.84mm) swap to Cyan
At layer #27 (2.24mm) swap to Orange
At layer #30 (2.48mm) swap to Yellow
At layer #34 (2.8mm) swap to Desert Tan
At layer #37 (3.04mm) swap to Sky Blue
At layer #39 (3.2mm) swap to Ivory White
This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.
Border Only Colors from here until the end.
At layer #47 (3.84mm) swap to Black for the rest.
Boost Me (for free)
Feel free to Boost If you like my work!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)