RC Car body post cutter
Print Profile(1)
Description
This a pair of tools to cut the body posts for an RC car and add a small chamfer to the top.
To use the cutter, put your lower split pin into the post where it would sit under the body and then push the post into the cutter until the pin hits the bottom. Then turn the thumbwheel to cut the post to approx 5mm above the split pin.
The post can be chamfered by pushing it in through the bottom side of the chamfer tool and rotating it against the blade.
Required parts for assembly:
2 standard Stanley Blades
2 M3x3 bolts (Chamfer tool)
2 M3 x 6 bolts (Cutter)
1 x M5x30 bolt (Head must be around 8mm across the flat sides). this goes through the thumbwheel.
Optional, not required:
M5 brass heat insert. If you don't have one of these you can print the 'NoInsert' variant of the main cutter body and manually thread the hole on it using a tap or the M5 bolt.
Optionally, you can also put a spring inbetween the main body and slide so that they separate automatically when you wind the thumbscrew out.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)