Dragon Dice Tower

Dragon Dice Tower

My children wanted their own dice tower, they wanted a dragon with an open mouth so they could feed it dice during the game (D&D) This is how the idea for this model came about

Dimensions: X= 185mm Y= 165mm Z= 190mm

Do not print this model with the STL file as the dice channel is not present there use the 3MF file and it only works with Bambu Slicer With other slicers the dice channel is not present

You can simply place the dice in its mouth and then push them into its throat 

I printed it with PLA Copper and in PLA Matte White 

I printed this V1 model multiple times and sometimes the supports looked quite different Make sure the supports look as much like the pictures as possible If they are very different you can reslice it again If this did not bring any change you can scale the model in Z by 2mm smaller or larger this will rearrange the support

With V2 this problem does not exist

For this model, use rather good filament, otherwise the print might not be perfectly clean in certain areas

When removing the supports, depending on the filament, the supports can be removed easily or with a bit more difficulty If the supports break and some still stick to the figure Be careful when removing the supports at the spikes on the chin as well as the teeth on top and it is best to use needle-nose pliers or side cutters to grip them cleanly and remove them towards the tip (not sideways) 

Be careful not to injure yourself on the lower teeth when removing the supports from the upper teeth

Have fun printing