Search models, users, collections, and posts
Modular Roof Edging & Corner Trim
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
3.9 h
4 plates
Open in Bambu Studio
Boost
11
47
2
2
9
6
Released
Bill of Materials
Bambu Filaments
Select all
Description
After re‑felting my shed roof, I designed these simple edging pieces to tidy the finish and help keep water out along the sides. The set includes side strips, corner pieces, and a few self‑adjusting sections for awkward spots.
Each piece has a slight overlap and measures 20 mm on both sides. I recommend printing in PETG for outdoor durability, with PLA as the support‑raft interface—PETG supports can be tough to remove cleanly.
If you’re looking for an easy, printable roof‑edging solution for your own shed, I hope this set helps.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)